Checkmate III

The Ultimate Diagnostic Tool for Irrigation Professionals

Checks All System Components

It’s an all-in-one system analyzer that uses the latest solid-state technology to simplify diagnostic testing.  In minutes, Checkmate III can tell you if valves are good or bad, solenoids are operating, wires are intact or controller outputs are adequate.

Amazingly Simple to Use

You don’t have to be an expert to use Checkmate III.  Each diagnosis is broken down into a series of pass-fail tests.  Just connect the alligator clips as prescribed and the test runs itself.   Easy indicator lights tell you the status of each system component. No knobs to turn, ranges to set, and no dials or meters to read.

Saves Valuable Time & Money

Tramping back and forth between valves and controllers, as well as carrying multimeters, tools, storage batteries, is exhausting and expensive.  The Checkmate III fits in the palm of your hand and is ready to go in a flash.  All of the instructions are right on the unit.  As an added convenience, there are never any batteries to buy.  The units built-in high-ampere rechargeable source lasts for hours.

A “Must” for Your Tool Box

No irrigation professional should be without this easy-to-use, all-in-one system analyzer.  It performs more diagnostic tests and is more versatile, reliable and rugged than any other tester, regardless of claims or price.  Add Checkmate III to your tool kit to save time and effort.

Comprehensive Testing

• Power test at valve location:  determines if solenoid is open, operational or shorted.  Special kick-start feature will electrically operate even high-draw valves.
• Power test valve and field wires from controller:  Valve test can be performed at controller.  If it fails, but works at the valve, a wiring problem is indicated.
• Controller output and wires test:  Determines if controller has adequate output.  Can test continuity of field wiring.

Model 860003: Supplied with re-charger and carrying case.

Our Family of Brands